![]() ![]() I mounted a bigger cooler (tricky), replaced 3 worn out caps and since then it‘s like new. The regulation design itself is top notch and imho one of the reasons for the low noise floor.įail of cooling is indicated by a high frequency noise audible from the unit - comes and goes, but eventually it won‘t start any more. (some heat dissipation via the circuit board and some via a small glued on cooler, that may come off) The cooling design of the internal voltage regulation was a bit too optimistic. But there was some 24/7 period of use, though. ![]() Today the ID22 (in particular 2nd hand) isn‘t recommended imho. In Multitrack DAW I could use the 2nd lowest latency 100% glitchfree, lowest latency had an occasional single click once every 1-3 minutes, but that was an older IOS version. but the audio performance justifies even it‘s restricted use (at least for me). UA Apollo Analog Classics Bundle Explained Mixing With UAD PluginsFab Dupont demonstrates the free UAD plugins that come with the UA Apollo interface. Routing and cue not available unless you connect a Mac/PC, do the setup and then connect the ID22 to an iPad without powering it down, a pain in the back tbh. The ID22 forgets everything once powered down, but the plain inputs are available in IOS. ![]() Well, I finally figured it out and wanted to share. Unfortunately Audient still does not supply an IOS version of their control panel software (only relevant for the ID22 and ID44)īut the ID44 stores a setup made on PC/Mac permanently onboard as it‘s new default. Wondered if anyone has been trying to use the UAD suite of plugins in Reason, without the need to bounce tracks or rewire into another host (Logic/Reaper/Ableton etc). ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |